Configuration for connecting a motion sensor to the Panasonic web camera.
Chris Womack - Louisiana Tech University - September 2002 - cwomack@latech.edu

Equipment:
==========
Panasonic Network Camera (Model KX-HCM10)
Radio Shack Passive Infrared Motion Sensor (Part # 49-208A)
CAT 5 wire


===================================================
Panasonic Network Camera (Model KX-HCM10) Settings:
===================================================

Image Transfer:Alarm
--------------------

(1) Operational Between
	Start 18:00
	Stop  08:00
	Mon-Fri
    Alarm enable condition: Rising: GND to Open (High), positive edge

(2) Secondary Time NOT Enabled

(3) Image resolution: 320x240
    Image quality: standard

(4) Pre-alarm Image Buffer ENABLED
    15 images per hour
    Max number of images per each trigger: 10

    Post-alarm image buffer: ENABLED
    15 images per hour
    Max number of images per each trigger: 10

(5) Transfer method
    FTP

(6) Notification when alarm occurs
    Mail


Digital Output Control: 
-----------------------

Short to GND




===============
Wiring Diagram:
===============

KX-HCM10              Radio Shack Motion Sensor (49-208A)
--------              -----------------------------------
Pin 1                 Alarm (-)
Pin 2                 Alarm (+)
Pin 3                 N.O. (adjacent to alarm +)
Pin 4                 N.O. (adjacent to NC terminal)

                      Lift jumper off P3 to select N.O. alarm output.